Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Universal Joint: Service and Repair
SPIDER BEARING REPLACEMENT
1. PLACE MATCHMARKS ON SHAFT AND YOKE
2. REMOVE SNAP RING
a. Using a brass bar and a hammer, slightly tap in the bearing outer race.
b. 4WD rear propeller shaft:
Using 2 screwdrivers, remove the 4 snap rings from the grooves.
c. 2WD and 4WD front propeller shaft:
Using needle nose pliers, remove the 4 snap rings from the grooves.
3. REMOVE SPIDER BEARING
a. Using SST, push out the bearing from the flange yoke.
SST 09332-25010
HINT: Sufficiently raise the part indicated by "A" so that it does not come into contact with the bearing.
b. Clamp the bearing outer race in a vise and tap off the flange with a hammer.
HINT: Remove the bearing on the opposite side in the same procedure.
c. Install the 2 removed bearing outer races to the spider, and clamp them in a vise.