Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
HINT: After cutting off the tip, use all adhesive within the time described in the table.
b. Load the cartridge into the sealer gun.
c. Coat the glass with adhesive as shown in the illustration.
Adhesive height: 13.5 mm (0.531 in.)
Adhesive width: 8.0 mm (0.315 in.)
7. INSTALL GLASS
a. Install the glass to the body.
b. Hold the glass in place securely with a protective tape or equivalent until the adhesive hardens.
NOTE: Take care not to drive the vehicle during the time described in the table.
8. INSPECT FOR LEAK AND REPAIR
a. Conduct a leak test after the hardening time has elapsed.
b. Seal any leak with sealant.
Part No. 0883-0030 or equivalent
9. INSTALL REAR WINDOW SIDE GARNISH
10. INSTALL REAR No.1 SEAT OUTER BELT SHOULDER ANCHOR
Torque: 42 N.m (430 kg.cm, 31 ft.lb)
11. INSTALL No.2 REAR WINDOW SIDE GARNISH
12. w/ Rear No.2 seat: INSTALL REAR No.2 SEAT OUTER BELT SHOULDER ANCHOR