Sequoia SR5 4WD V8-4.7L (2UZ-FE) (2001)
Take care not to scratch the serration of the speed sensor rotor.
13.
REMOVE AXLE HUB FROM STEERING KNUCKLE
A.
Remove the 4 bolts and shift the dust cover toward the hub side (outside).
B.
Using the following SSTs, remove the axle hub from the steering knuckle.
^
09710-28012-01 (09710-07031)
^
09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04031, 09957-04010, 09958-04011)
HINT:
If necessary, use a press to remove the axle hub from the steering knuckle.
C.
Remove the dust cover from the steering knuckle.
D.
4WD:
Remove the bearing spacer and ABS speed sensor rotor.
NOTE:
Take care not to scratch the serration of the speed sensor rotor.
14.
REMOVE OIL SEAL (OUTSIDE)
Using a screwdriver, remove the oil seal (outside) from the steering knuckle.
15.
REMOVE BEARING FROM STEERING KNUCKLE
A.
Using snap ring pliers, remove the snap ring.
B.
Using the following SSTs and a press, remove the bearing from the steering knuckle.
^
09950-60020 (09951-00810)
^
09950-70010 (09951-07150)
16.
INSTALL NEW BEARING