Sienna V6-3.0L (1MZ-FE) (2003)
Side Airbag Sensor Assembly
REMOVAL
NOTE:
-
If the wiring connector of the SRS is disconnected with the ignition switch at ON position, DTCs will be recorded.
-
Do not open the cover or the case of the ECU and various electrical devices unless absolutely necessary.
(If the IC terminals are touched, the IC may be destroyed by static electricity.)
1. REMOVE SLIDE DOOR SCUFF PLATE
2. REMOVE FRONT DOOR SCUFF PLATE
3. REMOVE CENTER PILLAR LOWER GARNISH
4. REMOVE RETRACTOR OF FRONT SEAT OUTER BELT