Sienna AWD V6-3.3L (3MZ-FE) (2004)
/Page-1420007.png)
NOTE: The check should be performed with the assembly installed.
1. Check that the belt cannot be pulled out any more but can be rewound after the belt is fully pulled out.
2. Check that the belt can be pulled out and rewound after the belt is fully rewound.
If operation is not as specified, replace the belt assembly.
14. INSTALL REAR NO.2 SEAT LAP BELT ASSEMBLY CENTER W/INNER LH (8- PASSENGER)
a. Install the lap belt with the bolt.
Torque: 42 Nm (420 kgf.cm, 31 ft.lbf)
15. INSTALL REAR NO.2 SEAT BELT ASSEMBLY 3 POINT TYPE
a. Install the seat belt with the 3 bolts and 2 nuts.
Torque: 42 Nm (430 kgf.cm, 31 ft.lbf) for bolt
b. Check the degree of tilt when the belt begins to lock the ELR.
1. Check that the belt does not lock within 15 ° of tilt in all directions but that the belt locks with over 45 ° of tilt, when gently moving the
retractor.
If operation is not as specified, replace the seat belt assembly.
c. Check the ELR lock.
NOTE: The check should be performed with the assembly installed.
1. Check that the belt locks when pulling out the belt quickly when the belt is installed.
If operation is not as specified, replace the belt assembly.
d. Check the fastening function of the child restraint system.
NOTE: The check should be performed with the assembly installed.
1. Check that the belt cannot be pulled out any more but can be rewound after the belt is fully pulled out.
2. Check that the belt can be pulled out and rewound after the belt is fully rewound.
If operation is not as specified, replace the belt assembly.
Rear Seat 3 Point Type Belt Assy Outer
