Sienna AWD V6-3.3L (3MZ-FE) (2004)
/Page-1254017.png)
n. Using SST, hold the control valve rotation and install a new lock nut.
SST 09616-00011
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)
o. Apply sealant to 2 or 3 threads of the rack housing cap.
Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
p. Using a socket wrench (27 mm), install the rack housing cap.
Torque: 59 Nm (597 kgf-cm, 43 ft. lbs.)
q. Using a punch and a hammer, stake the rack housing cap and rack housing.
43. INSTALL RACK GUIDE
a. Install the rack guide.
b. Install the compression spring.
c. Apply sealant to 2 or 3 threads of the rack guide spring cap.
Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
d. Temporarily install the rack guide spring cap.
44. ADJUST TOTAL PRELOAD
a. To prevent the steering rack teeth from damaging the oil seal lip, temporarily install the RH and LH steering rack ends sub-assy.
b. Using SST, torque the rack guide spring cap.
SST 09631-10021
Torque: 25 Nm (254 kgf-cm, 18 ft. lbs.)
