Sienna AWD V6-3.3L (3MZ-FE) (2004)
8. SEPARATE REAR DRIVE SHAFT INBOARD JOINT BOOT NO.2 CLAMP
a. Using a screwdriver, remove the inboard joint boot No.2 clamp.
b. Remove the inboard joint boot clamp by the same procedures as the inboard joint boot No.2 clamp.
9. SEPARATE RR DRIVE SHAFT INBOARD JOINT BOOT
a. Remove the inboard joint boot from the inboard joint assy.
10. REMOVE REAR DRIVE SHAFT INBOARD JOINT ASSY
a. Remove the circlip, place matchmarks on the inboard joint assy and outboard joint shaft.
NOTICE: Do not punch the marks.
b. Pull out the inboard joint assy.
NOTICE: Be careful not to drop the balls.
c. Place matchmarks on the outboard joint shaft, inner race and cage.
NOTICE: Do not punch the marks.
d. Remove the 6 bolts.
e. Slide the cage toward outboard joint.
f.
Using a snap ring expander, remove the snap ring.