Sienna AWD V6-3.5L (2GR-FE) (2007)
11. REMOVE CENTER PILLAR GARNISH LOWER RH
a. Remove the floor anchor cover.
b. Remove the bolt and disconnect the front seat outer belt on the floor anchor side.
c. Using a screwdriver, disengage the 5 clips and remove the pillar garnish.
HINT: Tape the screwdriver tip before use.
d. w/ power slide door:
Disconnect the power slide door control switch RH connector.
12. REMOVE CENTER PILLAR GARNISH LOWER LH
13. REMOVE CENTER PILLAR GARNISH UPPER RH
a. Using a screwdriver, disengage the assist grip plugs.
HINT: Tape the screwdriver tip before use.
b. Remove the 2 torx screws and assist grip No. 2 RH.