Sienna AWD V6-3.5L (2GR-FE) (2007)
6. LOOSEN BRAKE PEDAL SHAFT
(a)
Loosen the 2 brake pedal shafts.
7. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
(a)
Remove the 4 nuts and brake pedal support sub-assembly.
(b) Using needle-nose pliers, remove the tension spring.
(c)
Remove the clip and clevis pin from the brake pedal lever.
(d) Remove the 2 bolts from the brake pedal bracket No. 3.
(e)
Remove the stop light switch harness clamp from the brake pedal support sub-assembly.
(f)
Disconnect the stop light switch connector.
INSTALLATION
1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
(a)
Install the brake pedal support sub-assembly with the 4 nuts.
Torque: 16 Nm (160 kgf-cm, 12 ft. lbs.)
(b) Install the clip and clevis pin to the brake pedal lever.
(c)
Using needle-nose pliers, install the tension spring.