Sienna AWD V6-3.5L (2GR-FE) (2007)
(b) Immerse the thermostat in water and gradually heat the water.
(c)
Check the valve opening temperature.
Valve opening temperature: 80 to 84°C (176 to 183°F)
If the valve opening temperature is not as specified, replace the thermostat.
(d) Check the valve lift.
Valve lift: 7.7 mm (0.303 inch) or more at 95°C (203°F)
If the valve lift is not as specified, replace the thermostat.
(e)
Check that the valve is fully closed when the thermostat is at low temperatures (below 40°C (104°F)).
If it is not fully closed, replace the thermostat.
INSTALLATION
1. INSTALL THERMOSTAT
(a)
Install a new gasket to the thermostat.
(b) Install the thermostat with the jiggle valve facing up.
HINT: The jiggle valve may be set within 10° on either side of the prescribed position.
2. INSTALL WATER INLET
(a)
Install the water inlet with the 2 nuts.
Torque: 10 Nm (102 kgf-cm, 7 ft. lbs.)