Sienna AWD V6-3.5L (2GR-FE) (2007)
7. REMOVE BACK-UP LIGHT ASSEMBLY
a. Disconnect the connector.
b. Release the 2 claw fittings and remove the 4 nuts and the back-up light assembly.
INSTALLATION
1. INSTALL BACK-UP LIGHT ASSEMBLY
a. Connect the connector.
b. Install the back-up light assembly with the 4 nuts and 2 claws.
2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
3. INSTALL BACK DOOR PULL STRAP
4. INSTALL BACK DOOR STRAP COVER
5. INSTALL BACK DOOR SIDE GARNISH RH
6. INSTALL BACK DOOR SIDE GARNISH LH
7. INSTALL BACK DOOR GARNISH CENTER