Sienna AWD V6-3.5L (2GR-FE) (2007)
c. Remove the bolt on the retractor side and remove the NO.2 rear seat outer belt assembly.
INSTALLATION
1. INSTALL NO.2 REAR SEAT OUTER BELT ASSEMBLY
NOTE: Do not disassemble the retractor.
a. Check the degree of tilt when the NO.2 rear seat outer belt assembly begins to lock the ELR.
1. Check that the belt does not lock within 15° of tilt in all directions but that the belt locks with over 45° of tilt, when gently moving the
retractor.
If operation is not as specified, replace the NO.2 rear seat outer belt assembly.
2. Install the NO.2 rear seat outer belt assembly with the bolt on the retractor side.
Torque:
Upper bolt: 8.5 N.m (87 kgf.cm, 75 in.lbf)
Lower bolt: 42 N.m (430 kgf.cm, 31 ft.lbf)
3. Install the NO.2 rear seat outer belt assembly on the shoulder anchor side with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
2. INSTALL 3 POINT TYPE REAR SEAT BELT ASSEMBLY (for 8-Passenger)
NOTE: Do not disassemble the retractor.