Sienna AWD V6-3.5L (2GR-FE) (2007)
replace it with a new one.
-
When installing the rear airbag sensor LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched
between other parts.
d. Check that there is no looseness in the installation parts of the rear airbag sensor LH.
e. Connect the connector to the rear airbag sensor LH.
2. INSTALL AIR DUCT ASSEMBLY
3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH
4. INSTALL LAP BELT OUTER ANCHOR COVER
5. INSTALL BACK DOOR SCUFF PLATE
6. INSTALL BACK DOOR WEATHERSTRIP
7. INSTALL REAR DOOR WEATHERSTRIP RH
8. INSTALL REAR DOOR SCUFF PLATE RH
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. PERFORM INITIALIZATION
a. Perform initialization.
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
11. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light.