Sienna AWD V6-3.5L (2GR-FE) (2007)
/Page-303003.png)
other parts.
d. Check that there is no looseness in the installation parts of the side airbag sensor LH.
e. Connect the connector to the side airbag sensor
2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
3. INSTALL CENTER PILLAR GARNISH LOWER LH
4. INSTALL LAP BELT OUTER ANCHOR COVER LH
5. INSTALL REAR DOOR WEATHERSTRIP LH
6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
7. INSTALL FRONT DOOR SCUFF PLATE LH
8. INSTALL REAR DOOR SCUFF PLATE LH
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. PERFORM INITIALIZATION
a. Perform initialization.
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
11. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light.