Sienna AWD V6-3.5L (2GR-FE) (2007)
12. INSPECT STEERING RACK END SUB-ASSEMBLY
(a)
Ensure that the rack end sub-assembly hole is not clogged with grease.
HINT: If the hole is clogged, the pressure inside the boot will change after it is assembled and steering wheel is turned.
13. INSTALL STEERING RACK BOOT NO.2
14. INSTALL STEERING RACK BOOT NO.1
15. INSTALL STEERING RACK BOOT NO.2 CLAMP
(a)
Using SST, tighten the rack boot No.2 clamp, as shown in the illustration.
SST 09521-24010
Clearance: 3.0 mm (0.118 inch) or less
NOTICE: Be careful not to damage the rack boot No. 2.
16. INSTALL STEERING RACK BOOT NO.1 CLAMP
SST 09521-24010
HINT: Perform the same procedure on the other side.
17. INSTALL STEERING RACK BOOT CLIP
(a)
Using pliers, install the 2 rack boot clips.
18. INSTALL TIE ROD ASSEMBLY LH
(a)
Screw the lock nut and tie rod assembly onto the rack end sub-assembly until the matchmarks are aligned.
HINT: After adjusting toe-in, torque the lock nut.
19. INSTALL TIE ROD ASSEMBLY RH
HINT: Perform the same procedure on the other side.