Sienna AWD V6-3.5L (2GR-FE) (2007)
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a)
Install the park/neutral position switch to the manual valve shaft.
(b) Temporarily install the 2 bolts.
(c)
Place a new lock plate and tighten the nut.
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)
(d) Temporarily install the control shaft lever.
(e)
Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
(f)
Remove the control shaft lever.
(g) Align the groove with the neutral basic line.
(h) Hold the switch in position and tighten the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)