Sienna AWD V6-3.5L (2GR-FE) (2007)
10. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
(a)
Using SST, remove the front drive shaft assembly LH.
SST 09520-01010, 09520-24010 (09520-32040)
NOTICE:
^
Be careful not to damage the transaxle case oil seal, inboard joint boot and drive shaft dust cover.
^
Be careful not to drop the drive shaft assembly.
11. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for 2WD)
(a)
Using a screwdriver, remove the bearing brake hole snap ring.
(b) Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.
12. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for 4WD)
(a)
Using SST, remove the front drive shaft assembly RH.
SST 09520-01010, 09520-24010 (09520-32040)
HINT: Overhaul the side following the same procedures as for the LH side.
NOTICE:
^
When removing and installing the front drive shaft assembly RH in 4WD vehicle, be sure to first drain all the transaxle oil and transfer
oil. If removal and installation is carried out without draining these oils, the transfer oil will flow into the transaxle side. Extensive
cleaning will be required if the two oils mix.