Sienna AWD V6-3.5L (2GR-FE) (2007)
(e)
Using a SST, measure the clearance of the 2 outboard joint boot clamps.
SST 09240-00020
Clearance: 1.2 to 4.0 mm (0.047 to 0.157 inch)
NOTICE: When the measured value is greater than the specified value, retighten the clamp.
3. INSTALL REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY
(a)
Through a new inboard joint boot, 2 new inboard joint clamps and cage.
(b) Align the matchmarks, using a brass bar and a hammer, install the inner race.
(c)
Using a snap ring expander, install a new rear drive shaft snap ring.
(d) Align the matchmarks, install the cage to the inner race.
(e)
Install the 6 balls with grease to the inner race.
(f)
Pack the inboard joint shaft and boot with grease in the boot kit.
Grease capacity: 130 to 150 g (4.6 to 5.3 oz.)