Sienna AWD V6-3.5L (2GR-FE) (2007)
NOTE:
Remove/replace one bolt at a time and then torque each bolt to 8 N.m (82 kgf.cm, 71 in.lb).
7.
Assemble in reverse order of disassembly.
For additional information on replacing the window regulator bolts for the LH and RH sliding door, refer to the Technical Information System (TI S),
2007 model year Sienna Repair Manual, Vehicle Exterior - Door/Hatch - "Engine Hood/Door: Slide Door - 'Disassembly".
Use the following procedure for both LH and RH sliding doors.
1.
Remove the sliding door window garnish.
A.
Fully open the slide door window.
B.
Remove the glass run.
C.
Using the plastic pry tool, disengage the clip and remove the garnish.
D.
Using the plastic pry tool, disengage the 2 claws and remove the weatherstrip inner from the garnish.
2.
Remove the side trim board cover rear side trim board.
A.
Remove the 2 screws.
B.
Using the plastic pry tool, disengage the 8 claws and remove the cover together with the window control switch.
C.
Remove the 2 screws and window control switch.