Sienna FWD L4-2.7L (1AR-FE) (2011)
Torque: 31 N.m (316 kgf.cm, 23 ft.lbf)
4. To adjust the lower door seating position on the vehicle body surface vertically or to adjust the door position in the vertical and front-to-back
directions, fully close the slide door, loosen the bolt of the slide door lower roller, then check and adjust the door position.
Torque: 31 N.m (316 kgf.cm, 23 ft.lbf)
HINT:
-
To adjust the slide door lower roller arm on the door side, remove the rear door trim board.
-
To adjust the slide door lower roller base on the vehicle body side, disengage the slide door full open stop lock and temporarily install the
bolts.
5. To adjust the door position in the vertical, horizontal or front-to-back direction, loosen the bolts of the slide door roller before making an
adjustment.
Torque: 13 N.m (127 kgf.cm, 9 ft.lbf)
6. To adjust the door position vertically or horizontally at the slide door front lock striker plate, loosen the bolts for the slide door down female
stopper, then loosen the striker screws using a T40 "TORX" socket wrench so that the striker can move, and adjust the striker position by
tapping it lightly using a brass bar and a hammer.
Torque: 23 N.m (235 kgf.cm, 17 ft.lbf)