Sienna FWD L4-2.7L (1AR-FE) (2011)
Power Trunk / Liftgate Control Module: Technical Service Bulletins
Body - Power Liftgate Initialization Procedure
T-SB-0013-10
January 19, 2010
Initialization of Power Back Door During PDS
Service Category
General
Section
Pre-Delivery Service
Market
USA
Applicability
Introduction
As a result of the removal of the Short Pin, the "automatic open and close" and "jam protection" functions of the power back door will be inoperative due
to loss of the power back door position.
Initialize the power back door after installing the Short Pin in its original location during Pre-Delivery Service (PDS).
NOTE
^
Any time the battery terminal has been disconnected, the power back door may need to be re-initialized.
^
If the short pin is installed with the power sliding doors fully closed, the initialization may not be required because the power sliding door
position memory is still stored in the microcomputer.
Warranty Information