Sienna FWD V6-3.3L (3MZ-FE) (2006)
Distance Sensor: Adjustments
NOTE: This article contains updated information called out by TSB# SB-0077-09 (Rev.1).
LASER CRUISE CONTROL BEAM ADJUSTMENT
Service Category: Engine/Hybrid System
Section: Cruise Control
Market: USA
Applicability
TSB SUPERSESSION NOTICE
The information contained in this TSB supersedes TSB No. EL012-05.
-
Applicability has been updated to include 07-09 model years Avalon and Sienna vehicles.
TSB No. EL012-05 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before
proceeding.
Introduction
When the laser cruise control sensor is removed from the vehicle for trouble diagnosis or repair, it is necessary to adjust the laser beam axis after the
operation. Use the following procedure to perform laser cruise control beam axis adjustments.
Required Tools & Equipment
*
Essential SST.
Tools & Materials
Warranty Information
Preparation Procedure
HINT
-
It is important that the laser sensor, bumper reinforcement, etc., are installed properly.
-
The sensor and bracket are a matched set and must be replaced as an assembly. If the sensor is removed from the matched bracket, the adjustment
may be affected.
-
Please ensure that the battery is disconnected prior to laser radar sensor disconnect.
NOTE
-
Perform measurement indoors on level ground and in front of a blank wall. Park the vehicle at least 29.5 ft (9 m) from the wall. When performing