Sienna FWD V6-3.3L (3MZ-FE) (2006)
Parking Assist Distance Sensor: Service and Repair
No. 1 Ultrasonic Sensor
REMOVAL
1.
REMOVE FRONT FENDER LINER LH
2.
REMOVE FRONT FENDER LINER RH
3.
REMOVE FRONT BUMPER COVER
4.
REMOVE REAR BUMPER COVER
5.
REMOVE NO. 1 ULTRASONIC SENSOR RETAINER
a.
Remove the No. 1 ultrasonic sensor retainer as shown in the illustration.
6.
REMOVE NO. 1 ULTRASONIC SENSOR
a.
Disconnect the connector and remove the No. 1 ultrasonic sensor.
INSTALLATION
1.
INSTALL NO. 1 ULTRASONIC SENSOR
a.
Connect the connector and install the No. 1 ultrasonic sensor.