Sienna FWD V6-3.3L (3MZ-FE) (2006)
NOTE:
When drilling and welding the door, be sure to protect other components of the door, either by covering them or removing them.
3.
Fill the drilled area using a MIG welder to connect all panels.
4.
Use an appropriate color touch up paint on the welded material.
NOTE:
When touching up or fogging in paint, be sure to protect unaffected areas of the door and vehicle from overspray.
Technical Service
Bulletin # NV003R-07
Date: 071128
Body - Popping Noise Upon Opening/Closing Front Doors
NVH
NV003-07
REVISED
Title:
DOOR CHECK POPPING NOISE
Models:
'04 - '06 Sienna
March 23, 2007
TSB REVISION NOTICE:
^
November 28, 2007: The note below the Warranty Information table has been updated.
^
July 6, 2007: The Warranty Information table has been updated with separate "Combo A" Op Codes.
^
May 29, 2007: The Warranty Information has been updated. The note before step 1 of the Repair Procedure has been updated.
Previous versions of this TSB should be discarded.
Introduction
Some customers may experience a popping noise when opening and/or closing the front doors on their vehicle. Use the following procedure to diagnose
and correct the condition.
Applicable Vehicles
^
2004 - 2006 model year Sienna vehicles produced BEFORE the Production Change Effective VINs shown below.