Sienna FWD V6-3.3L (3MZ-FE) (2006)
Liftgate Window Glass: Service and Repair
REMOVAL
1. REMOVE BACK DOOR GARNISH CENTER
2. REMOVE BACK DOOR SIDE GARNISH LH
3. REMOVE BACK DOOR SIDE GARNISH RH
4. REMOVE BACK DOOR STRAP COVER
5. REMOVE BACK DOOR PULL STRAP
6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
7. REMOVE BACK DOOR SERVICE HOLE PLATE
8. REMOVE REAR SPOILER COVER (W/ REAR SPOILER)
9. REMOVE FRONT WIPER ARM HEAD CAP
10. REMOVE REAR WIPER ARM
11. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY
12. REMOVE BACK DOOR GLASS
a. Pass a piano wire between the body and glass from the interior.
b. Tie both wire ends to wooden blocks or similar objects.
HINT: Apply protective tape to the outer surface to prevent the surface from being scratched.
NOTE: When separating the glass, take care not to damage the paint and interior and exterior ornaments.
c. Cut off the adhesive by pulling piano wire around it.
d. Using a suction rubber, remove the glass.
NOTE: Leave as much adhesive on the body as possible when removing the glass.