Sienna FWD V6-3.3L (3MZ-FE) (2006)
c. Using a brush or sponge, coat the edge of the glass and the contact surface with Primer G.
HINT: If an area other than that specified is coated by accident, wipe of the primer with a clean shop rag before it dries.
NOTE:
-
Allow the primer coating to dry for 3 minutes or more.
-
Do not keep any of the opened Primer G for later use.
d. Apply adhesive.
Adhesive: Part No. 08850-00801 or equivalent
1. Cut off the tip of the cartridge nozzle, as shown in the illustration.
HINT: After cutting off the tip, use all adhesive within the time described in the table.
2. Load the sealer gun with the cartridge.