Sienna FWD V6-3.3L (3MZ-FE) (2006)
4.
Remove power back door touch sensor LH.
A.
Remove the 4 screws.
B.
Using a clip remover, remove the clip and touch sensor.
5.
Install the NEW power back door touch sensor LH.
A.
Install the touch sensor with the clip.
B.
Using a Torx driver (T25), tighten the 4 screws.
6.
Verify the power back door operates correctly.
Sensor shown on LH side is typical of RH side sensor.
Power Sliding Doors:
1.
Using TIS techstream, monitor the left or right sliding door ECU Data List and compare the results with the chart.
^
System Select/Left Sliding Door ECU/Data List System Select/Right Sliding Door ECU/Data List
^
If TIS techstream indicates the sensor is OFF with the sliding door closed, open the door manually and recheck sensor indication.
^
If the sensor remains OFF, the sensor is normal.
^
If TIS techstream indicates the sensor is ON with the sliding door open and the sensor is NOT being pressed, replace the sensor.