Sienna FWD V6-3.3L (3MZ-FE) (2006)
Brake Pedal Assy: Testing and Inspection
ON-VEHICLE INSPECTION
1. INSPECT BRAKE PEDAL HEIGHT
a) Check the brake pedal height.
Pedal height from dash panel: 150.3 to 160.3 mm (5.917 to 6.311 inch)
NOTICE: Do not adjust the pedal height. Doing so by changing the push rod length will structurally change the pedal ratio.
2. CHECK AND ADJUST STOP LIGHT SWITCH
a) Disconnect the stop light switch assembly connector from the stop light switch assembly.
b) Turn the stop light switch assembly counterclockwise and remove the stop light switch assembly.
c) Insert the stop light switch assembly until the body hits the cushion.
NOTICE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
d) Make a quarter turn clockwise to install the stop light switch assembly.
NOTICE:
^
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
^
The turning torque for installing the stop light switch assembly.
Torque: 1.5 Nm (15 kgf-cm, 13 inch lbs.) or less