Sienna FWD V6-3.3L (3MZ-FE) (2006)
2. INSTALL PARKING BRAKE SHOE LEVER LH
a) Install the shoe lever and shim to the rear shoe with a new C-washer.
b) Using a feeler gauge, measure the clearance.
Standard clearance: Less than 0.35 mm (0.0138 inch)
If the clearance is not within the specification, replace the shim with one of the correct size.
c) Install the correct side shim with a new C-washer.
d) Remeasure the clearance.
3. INSTALL PARKING BRAKE SHOE ASSEMBLY LH NO.2
a) Using needle-nose pliers, connect the parking brake cable No. 3 to the parking brake shoe lever.
b) Install the parking brake shoe assembly LH No. 2 with the shoe hold-down compression spring pin No. 2, shoe hold-down compression spring
and 2 cups.
4. INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET
a) Apply the high temperature grease to the adjusting bolt.