Sienna FWD V6-3.3L (3MZ-FE) (2006)
a) Using SST, hold the crankshaft.
SST 09213-54015 (91651-60855), 09330-00021
b) Clean the bolts and the bolt holes.
c) Apply adhesive to 2 or 3 threads of the bolts.
Adhesive: Part No. 08833-00070, THREE BOND 1324 or equivalent
d) Install the front spacer, the drive plate and the rear spacer on the crankshaft.
e) Using several steps, install and tighten the 8 bolts uniformly in the sequence shown in the illustration.
Torque: 83 Nm (846 kgf-cm, 61 ft. lbs.)
NOTICE: Do not start the engine within an hour after installing.
3. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER (for 4WD)
4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)