Sienna FWD V6-3.3L (3MZ-FE) (2006)
b) Install a new gasket to the exhaust pipe front as shown in the illustration.
c) Install the exhaust pipe center to the 2 exhaust pipe supports.
d) Tighten the 2 compression springs and the 2 bolts.
Torque: 43 Nm (438 kgf-cm, 32 ft. lbs.)
3. INSTALL EXHAUST PIPE ASSEMBLY TAIL
a) Install anew gasket and the exhaust pipe tail to the 3 exhaust pipe supports.
b) Tighten the 2 bolts.
Torque: 43 Nm (438 kgf-cm, 32 ft. lbs.)
4. INSTALL OXYGEN SENSOR
Torque: 44 Nm (450 kgf-cm, 33 ft. lbs.)
5. CHECK FOR EXHAUST GAS LEAKS
6. INSTALL FLOOR CARPET COVER CENTER LH