Sienna FWD V6-3.3L (3MZ-FE) (2006)
d. Disconnect the cooler refrigerant liquid pipe (to cooler unit).
NOTE:
-
Do not use tools like a screwdriver to remove the tube.
-
Seal the opening of the disconnected parts using vinyl tape to prevent moisture and foreign matters from entering.
9. DISCONNECT SUCTION HOSE SUB-ASSEMBLY
SST 09870-00015
HINT: Disconnection of the pipe cooler refrigerant suction hose sub-assembly is the same way as the cooler refrigerant liquid pipe E (to cooler
unit).
10. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
11. DISCONNECT HEATER WATER OUTLET HOSE A (FROM HEATER UNIT)
a. Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water outlet hose A (from heater unit).
12. REMOVE HEATER WATER INLET HOSE A
HINT: Disconnection of the heater water inlet hose A is the same way as the heater water outlet hose A (from heater unit).
13. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY WITH PASSENGER AIRBAG ASSEMBLY
HINT: Refer to the instructions for removal of the instrument panel sub-assembly w/ passenger airbag assembly
14. REMOVE HEATER TO FOOT DUCT NO.3
a. Remove the clip and the heater to foot duct No. 3.