Sienna FWD V6-3.3L (3MZ-FE) (2006)
Backup Lamp: Service and Repair
Removal and Installation
REMOVAL
1. REMOVE BACK DOOR GARNISH CENTER
2. REMOVE BACK DOOR SIDE GARNISH LH
3. REMOVE BACK DOOR SIDE GARNISH RH
4. REMOVE BACK DOOR STRAP COVER SUBASSEMBLY
5. REMOVE BACK DOOR PULL STRAP
6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
7. REMOVE BACK-UP LIGHT ASSEMBLY
a. Disconnect the connector.
b. Release the 2 claw fittings and remove the 4 nuts and the back-up light assembly.
INSTALLATION
1. INSTALL BACK-UP LIGHT ASSEMBLY
a. Connect the connector.
b. Install the back-up light assembly with the 4 nuts and 2 claws.
2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
3. INSTALL BACK DOOR PULL STRAP
4. INSTALL BACK DOOR STRAP COVER
5. INSTALL BACK DOOR SIDE GARNISH RH
6. INSTALL BACK DOOR SIDE GARNISH LH
7. INSTALL BACK DOOR GARNISH CENTER