Sienna FWD V6-3.3L (3MZ-FE) (2006)
6. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH
a. Remove the 4 bolts and hub & bearing assembly LH.
INSTALLATION
1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
a. Install the hub & Bearing assembly LH with the 4 bolts.
Torque: 56 Nm (571 kg-cm, 41 ft. lbs.)
2. INSPECT BEARING BACKLASH
3. INSPECT AXLE HUB DEVIATION
4. CONNECT SKID CONTROL SENSOR WIRE
a. Connect the connector.
NOTICE: Do not twist the sensor wire when connecting it.
5. INSTALL REAR DISC
a. Install rear disc for disc rear brake type.
6. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
a. Install rear brake drum sub-assembly for drum rear brake type.
7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
a. Install the rear disc brake caliper assembly LH with the 2 bolts for disc rear brake type.
Torque: 88 Nm (900 kg-cm, 65 ft. lbs.)
8. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kg-cm, 76 ft. lbs.)
9. CHECK ABS SPEED SENSOR SIGNAL
a. ABS WITH EBD SYSTEM.
b. ABS WITH EBD & BA & TRAC & VSC SYSTEM.