Sienna FWD V6-3.3L (3MZ-FE) (2006)
Auxiliary Power Outlet: Service and Repair
Voltage Inverter
REMOVAL
1. REMOVE REAR DOOR SCUFF PLATE LH
2. REMOVE REAR DOOR WEATHERSTRIP LH
3. REMOVE BACK DOOR WEATHERSTRIP
4. REMOVE BACK DOOR SCUFF PLATE
5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY LH
6. REMOVE VOLTAGE INVERTER ASSEMBLY
a. Disconnect the connector.
b. Remove the 2 bolts and the voltage inverter assembly.
INSTALLATION
1. INSTALL VOLTAGE INVERTER ASSEMBLY
a. Install the voltage inverter assembly with the 2 bolts.
Torque: 5.4 N.m (55 kgf.cm, 47 in.lbf)
NOTE: Tighten the bolts in order shown in the illustration to in the voltage inverter assembly.
2. INSTALL QUARTER TRIM FRONT PANEL ASSEMBLY LH
3. INSTALL BACK DOOR SCUFF PLATE
4. INSTALL BACK DOOR WEATHERSTRIP
5. INSTALL REAR DOOR WEATHERSTRIP LH
6. INSTALL REAR DOOR SCUFF PLATE LH