Sienna FWD V6-3.3L (3MZ-FE) (2006)
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION SENSOR
REMOVAL
1. REMOVE FRONT FENDER APRON SEAL RH
a. Using a clip remover, remove the clip.
b. Remove the 2 blots and the front fender apron seal.
2. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the crankshaft position sensor connector.
b. Remove the bolt and the crankshaft position sensor.
INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
Torque: 8.0 N.m (80 kgf.cm, 71 in.lbf)
2. INSTALL FRONT FENDER APRON SEAL RH