toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Engine Controls - Techstream(R) ECU Re-Flash Procedure|Page 354 > < Engine Controls - Techstream(R) ECU Re-Flash Procedure|Page 352
Page 1
background image

Engine Control Module: Technical Service Bulletins
Engine Controls - Entering VIN When Replacing PCM/ECM

ENGINE
EG045-04

Title:
ENTERING VIN DURING ECM (PCM)
REPLACEMENT AND/OR DTC P0630

Models:
All '04 - '06 Models

October 14, 2004

TSB REVISION NOTICE:

^

June 3, 2005: Content has been updated to include 2004 and 2006 model year vehicles. Highlander HV has been added to step 4 of the VIN
Write Procedure. Step 3 of the VIN Read Procedure has been clarified to include Prius and Highlander HV vehicles.

^

January 24, 2005: Step 4 has been clarified to include Prius vehicles. Previous versions of this TSB should be discarded.

Introduction

All 2005 and subsequent model year Toyota and Scion vehicles have the VIN (Vehicle Identification Number) stored in the Electronic Control Module
(ECM) (SAE term: Powertrain Control Module/PCM) non-volatile memory. The VIN is accessible on the data stream using the Toyota Diagnostic
Tester and can also be written to a new ECM (PCM) using a VIN Read/Write" utility.

Service ECMs (supply parts) are shipped without the VIN; therefore, as part of the ECM (PCM) replacement procedure, the VIN must be written to the
replacement ECM (PCM) using the Diagnostic Tester utility function.

For most 2005 model year vehicles, failure to write the VIN to the ECM (PCM) will result in a M.I.L. "ON" condition and set DTC P0630: VIN Not
Programmed or Mismatch - ECM (PCM). The five models listed below do not support DTC P0630.

^

Corolla

^

ECHO

^

Matrix

^

Scion xA

^

Scion xB

It is very important to remember to enter the VIN on these vehicles. Vehicles with missing VINs are subject to failing some state and local vehicle
emissions Inspection and Maintenance programs.

NOTE:

2004 model year vehicles which have been flash reprogrammed may contain updated 2005 model year OBD II logic. These vehicles will require
VIN entry into the ECM (PCM) after reprogramming.

Applicable Vehicles

^

2004 model year vehicles that have been flash reprogrammed. 

^

All 2005 - 2006 model year vehicles.

Warranty Information

Engine Controls - Techstream(R) ECU Re-Flash Procedure|Page 354 > < Engine Controls - Techstream(R) ECU Re-Flash Procedure|Page 352