Sienna FWD V6-3.3L (3MZ-FE) (2006)
1. INSTALL SPIRAL CABLE
a. Check that the front wheels are facing straight ahead.
b. Set the turn signal switch to the neutral position.
NOTE: If it is not in the neutral position, the pin of the turn signal switch may snap.
c. Install the spiral cable.
NOTE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
d. Connect the connectors to the spiral cable.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL STEERING COLUMN COVER
a. Install the steering column cover with the 2 screws.
3. ADJUST SPIRAL CABLE
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
c. Rotate the spiral cable counterclockwise slowly by hand until it feels firm.
NOTE: Do not turn the spiral cable by the airbag wire harness.