Sienna FWD V6-3.3L (3MZ-FE) (2006)
Seat Belt: Procedures
Front Seat Inner Belt Assembly
REMOVAL
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY
HINT: Refer to the instructions for disassembly of the front seat assembly.
a. Remove the nut and front seat inner belt assembly.
INSTALLATION
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY
HINT: Refer to the instructions for reassembly of the front seat assembly.
a. Install the front seat inner belt assembly with the nut.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
Removal and Installation
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
2. REMOVE FRONT SEAT ASSEMBLY
3. REMOVE FRONT DOOR SCUFF PLATE.
4. REMOVE REAR DOOR SCUFF PLATE .
5. REMOVE FRONT DOOR WEATHERSTRIP.
6. REMOVE REAR DOOR WEATHERSTRIP.
7. REMOVE CENTER PILLAR LOWER GARNISH.
8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY
NOTE:
-
Removal operation concerning the seat belt with the pretensioner must be started in 90 seconds or more after the ignition switch is turned OFF
and the battery negative terminal is disconnected.
-
Carefully read the notices for the "pretensioner" in the SRS airbag system and the outer belt assembly.
a. Remove the floor anchor cover.
b. Remove the bolt and the front seat outer belt assembly on the floor anchor side.
c. Remove the nut and the front seat outer belt assembly on the shoulder anchor side.
d. Disconnect the pretensioner connector, as shown in the illustration.
e. Remove the 2 bolts and front seat outer belt assembly.
9. REMOVE CENTER PILLAR UPPER GARNISH
10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
a. Remove the bolt and front shoulder belt anchor adjuster assembly.
INSTALLATION
1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY