Sienna FWD V6-3.3L (3MZ-FE) (2006)
Impact Sensor: Service and Repair
Side Airbag Sensor
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read "Air Bag Systems; Service Precautions" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE FRONT DOOR SCUFF PLATE LH
4. REMOVE REAR DOOR SCUFF PLATE LH
5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
6. REMOVE REAR DOOR WEATHERSTRIP LH
7. REMOVE LAP BELT OUTER ANCHOR COVER LH
8. REMOVE CENTER PILLAR GARNISH LOWER LH
9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY
10. REMOVE SIDE AIRBAG SENSOR LH
a. Disconnect the connector from the side airbag sensor LH.
b. Remove the 2 nuts and the side airbag sensor LH.
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. INSTALL SIDE AIRBAG SENSOR LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
c. Install the side airbag sensor LH with the 2 nuts.