Sienna FWD V6-3.3L (3MZ-FE) (2006)
/Page-106002.png)
adjustment outdoors, make sure that it is NOT raining or snowing.
-
Check that there are no reflective materials in the surroundings or on the ground. If you cannot secure a distance of about 29.5 ft (9 m) in front of
the vehicle, be sure to secure at least 23 ft (7 m) from the vehicle and cover the area marked [A] with a black cloth. If NOT covered with a black
cloth, the laser sensor may detect something other than the target and it will fail to adjust properly.
1. Preparation for Adjusting the Laser Beam Axis:
A. Adjust the tire pressure properly.
-
Refer to the tire pressure information label located in the door jamb for proper tire inflation or refer to the Owners Manual (Or Tire and
Wheel Specifications).
B. Make sure that the trunk and passenger compartment is unloaded.
C. Clean the light-luminous and light-receiving portions of the laser sensor.
D. Prepare a 10 m (33 ft) string, a string with a sharp-pointed weight, and a 5 m (25 ft standard) tape measure.
2. Reflector (SST) Placement:
A. Measure the height to the center of the laser luminous portion, as shown in the illustration.
