Sienna FWD V6-3.3L (3MZ-FE) (2006)
^
If the sensor is normal, refer to the Repair Manual for diagnostics.
^
If the sensor is open, inspect the sensor resistance.
^
Inspect the resistance of the sensor.
^
If the resistance of the sensor is normal, refer to the Repair Manual for diagnostics.
^
If the resistance of the sensor is NOT as specified, replace the sliding door touch sensor.
2.
Remove rear door trim board sub-assembly LH.
A.
Remove the screw.
B.
Using a plastic pry tool, disengage the 9 clips and remove the trim board.
HINT:
In order to prevent the door panel from being damaged, cover the areas with protective tape as indicated by the arrow marks in the illustration.