Sienna FWD V6-3.3L (3MZ-FE) (2006)
c. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub.
SST 09520-00031 (09520-00040), 09521-00020, 09950-00020
NOTE:
-
If a damage is inflicted to the sensor rotor is damaged, replace the axle hub assembly.
-
Do not scratch the contacting surface of the axle hub and speed sensor.
INSTALLATION
HINT: Install the RH side by the same procedure as the LH side.
1. INSTALL REAR SPEED SENSOR
a. Clean the contacting surface of the axle hub and a new skid control sensor.
NOTE: Keep the sensor rotor clean.
b. Place the speed sensor on the axle hub so that the connector is positioned as shown in the illustration.