Sienna FWD V6-3.3L (3MZ-FE) (2006)
Impact Sensor: Service and Repair
Rear Airbag Sensor
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read "Air Bag Systems; Service Precautions" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE REAR DOOR SCUFF PLATE RH
4. REMOVE REAR DOOR WEATHERSTRIP RH
5. REMOVE BACK DOOR WEATHERSTRIP
6. REMOVE BACK DOOR SCUFF PLATE
7. REMOVE LAP BELT OUTER ANCHOR COVER
8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
9. REMOVE AIR DUCT ASSEMBLY
a. Remove the screw and the air duct assembly.
10. REMOVE REAR AIRBAG SENSOR LH
a. Disconnect the connector from the rear airbag sensor LH.
b. Remove the 2 bolts and the rear airbag sensor LH.
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. INSTALL REAR AIRBAG SENSOR LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.