Sienna FWD V6-3.3L (3MZ-FE) (2006)
/Page-1128002.png)
c. Remove the flow control valve and the compression spring.
3. REMOVE VANE PUMP BRACKET REAR
a. Remove the 2 bolts, nuts, and the vane pump bracket rear from the vane pump assembly.
4. REMOVE VANE PUMP HOUSING REAR
a. Remove the 4 bolts and the vane pump housing rear from the vane pump housing front.
b. Remove the gasket.
c. Remove the 2 O-rings from the vane pump housing rear.
5. REMOVE VANE PUMP SIDE PLATE REAR
a. Remove the wave washer from the vane pump side plate rear.
b. Remove the vane pump side plate rear.
6. REMOVE VANE PUMP CAM RING
7. REMOVE VANE PUMP SHAFT SNAP RING
a. Using a screwdriver, remove the vane pump shaft snap ring from the w/pulley shaft sub-assembly.
8. REMOVE VANE PUMP ROTOR
a. Remove the 10 vane pump plates from the vane pump rotor.
b. Remove the vane pump rotor.
9. REMOVE W/PULLEY SHAFT SUB-ASSEMBLY
10. REMOVE PUMP BRACKET FRONT
a. Remove the bolt and the pump bracket front from the vane pump housing front.
11. REMOVE VANE PUMP HOUSING OIL SEAL
a. Using a screwdriver, remove the vane pump housing oil seal from the vane pump housing front.
NOTICE: Be careful not to damage the bushing of the vane pump housing front.
