Sienna FWD V6-3.3L (3MZ-FE) (2006)
11. INSTALL VANE PUMP BRACKET REAR
a. Install the vane pump bracket rear with the 2 bolts and nuts.
Torque: 44 Nm (449 kg-cm, 32 ft. lbs.)
12. INSTALL FLOW CONTROL VALVE
a. Coat the compression spring with power steering fluid and install it.
b. Coat the flow control valve with power steering fluid.
c. Install the flow control valve.
NOTICE: Make sure that the flow control valve is installed facing in the correct direction.
d. Coat a new O-ring with power steering fluid and install it onto the pressure port union.
e. Install the pressure port union.
Torque: 83 Nm (846 kg-cm, 61 ft. lbs.)
13. INSTALL POWER STEERING SUCTION PORT UNION
a. Coat a new O-ring with power steering fluid and install it onto the suction port union.
b. Install the suction port union with the bolt.
Torque: 13 Nm (1133 kg-cm, 10 ft. lbs.)