Sienna FWD V6-3.3L (3MZ-FE) (2006)
6. REMOVE TIE ROD ASSEMBLY RH
HINT: Perform the same procedure on the other side.
7. REMOVE STEERING RACK BOOT CLIP
a. Remove the 2 rack boot clips.
8. REMOVE STEERING RACK BOOT NO.2 CLAMP
a. Using pliers, remove the rack boot No.2 clamp.
NOTICE: Be careful not to damage the steering rack boot No.2.
9. REMOVE STEERING RACK BOOT NO.1 CLAMP
HINT: Perform the same procedure on the other side.
10. REMOVE STEERING RACK BOOT NO.2
11. REMOVE STEERING RACK BOOT NO.1
12. REMOVE STEERING RACK END SUB-ASSEMBLY
a. Using a screwdriver and a hammer, unstake the claw washer.
NOTICE: Avoid any impact to the power steering rack.
b. Using 2 SST, remove the 2 steering rack end sub assembly and 2 claw washers.
SST 09922-10010
NOTICE:
^
Use SST 09922-10010 in the direction shown in the illustration.
^
Securely hold the power steering rack end with a SST.