Sienna FWD V6-3.3L (3MZ-FE) (2006)
/Page-1162011.png)
14. INSTALL SPEED SENSOR REAR RH (for 4WD)
HINT: Install the RH side by same procedures as the LH side.
15. CONNECT SKID CONTROL SENSOR WIRE (for 2WD)
a. Connect the skid control sensor connector.
b. Install the bolt and bracket to the rear axle beam assembly.
Torque: 8.0 Nm (82 kg-cm, 71 inch lbs.)
HINT: Connect the RH side by same procedures with the LH side.
16. INSTALL EXHAUST PIPE ASSEMBLY TAIL
17. BLEED BRAKE LINE
18. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
19. STABILIZE SUSPENSION
a. Install the rear wheel and jack down the vehicle.
Torque: 103 Nm (1,050 kg-cm, 76 ft. lbs.)
b. Bounce the vehicle up and down several times to stabilize the suspension.
20. FULLY TIGHTEN SHOCK ABSORBER ASSEMBLY REAR LH
a. Stabilize the shock absorber assembly rear LH.
If it is impossible to tighten the nut at this position, support the rear axle beam assembly with a jack and load the rear compartment with a mass
of approximately 90 kg (198 lb).
Length of shock absorber:
2WD DRIVE TYPE: 234 mm (9.2 inch)
4WD DRIVE TYPE: 258 mm (10.2 inch)
b. Fully tighten the nut.
Torque: 115 Nm (1,173 kg-cm, 85 ft. lbs.)
21. FULLY TIGHTEN SHOCK ABSORBER ASSEMBLY REAR RH
