Sienna FWD V6-3.3L (3MZ-FE) (2006)
/Page-858003.png)
2. INSPECT SPEED SENSOR (NC SENSOR)
a. Disconnect the speed sensor connector from the transaxle.
b. Measure the resistance according to the value(s) in the table below.
Aisin Made Resistance
Toyota Made Resistance
INSTALLATION
1. INSTALL SPEED SENSOR (NC SENSOR)
a. Coat the O-ring with ATF.
b. Install the speed sensor with the bolt.
Torque: 11 Nm (115 kg-cm, 8 ft. lbs.)
HINT: Make sure to install the same manufacturer's sensor.
c. Connect the speed sensor connector.
2. INSTALL SPEED SENSOR (NT SENSOR)
