Sienna FWD V6-3.3L (3MZ-FE) (2006)
2. ADJUST SHIFT LEVER POSITION
a. Loosen the nut on the control shaft lever.
b. Push the control shaft fully downward.
c. Return the control shaft lever 2 notches to the N position.
d. While pushing the control cable end up with the shift lever in the N position, install it to the control shaft lever with the nut.
Torque: 13 Nm (132.6 kg-cm, 9.5 ft. lbs.)
NOTICE:
^
If the control cable end is excessively pushed up, the shift lever can not be adjusted.
^
When tightening the nut, confirm that the control cable is properly stretched.
e. Start the engine and make sure that the vehicle moves forward when shifting the lever from the N to D position and moves rearward when
shifting it to the R position.
REASSEMBLY